• Tommy D
  • Tommy D
  • Tommy D

Princess Cut Engagement Ring

A very Modern setting done in 18ct white gold and also a quite modern diamond shape, the Princess-cut.

Set in small corner claws and the smaller ones on the side are channel-set down the shank of the engagement ring.

1,6ct Diamond Engagement Ring

A very good example of when you spend just that little bit extra!

This ring looks stunning from all angles and I even had space to set small 1/2pt diamonds on the side of the gallery setting. The round brilliant cut diamond is a 1,6ct ( about 7,5mm diameter) and has a “H” colour.

Platinum Diamond Ring

On this Multi-stone diamond engagement ring I used square wire claws instead of the normal round wire claws.

The ring is made in platinum and I also did whats called an OP shank (Ring) which is where a section of the ring is flattened at the bottom to stop the solitaire from falling side-to-side when on the finger

Three Diamond Engagement Ring

A classical setting done in 18ct white gold.

The centre stone is a 75pt round brilliant cut diamond-claw-set and the two stones on the side are pear-shape diamonds of 18pts each.  The diamonds are set on a double gallery setting with a pinched shank.

Diamond Bangles

These are three hand-made diamond bangles.

each bangle is individually rolled, bent,knocked and drilled int a 4-claw setting bangle. I’ve used 175 round brilliant cut diamonds with a total diamond weight of 12,25 ct.

Claw-set Round Diamond Ring

A very impressive looking ring when I finished it.

The use of more diamonds than gold really works well for this design if you are after something that draws attention.

all the round brilliant cut diamonds have been claw-set and they are all touching.

White & Yellow Diamond Bands

Two 18ct yello and white Gents diamond wedding bands with cut-out designs on the inside and 2pt. diamonds that are pave-set on the top.

each ring is quite heavy with a weight of about 23grams each.

Open Tube Diamond Ring

This ring is a two-tone engagement ring.  the head or setting is done in 18ct white gold and the shank part is in 18ct yellow gold.

The centre round brilliant cut diamond is set in a open tube setting to allow for more light on the stone.

Cushion Diamond Ring

This ring is done in 18ct. white gold.  The shank(ring bands) are 2 mm wide and I’ve done a very soft taper towards the bottom.

The centre stone is a round brilliant cut diamond of 70pts. and 20x little round diamonds are pave-set on a flat edge, finished with a millgrain effect

Diamond Drop Earrings

These are by far my favourite pieces at the moment! they are absolutely exquisite if you had to see them up close, even from across the room.  I’ve used ten 30pt round brilliant cut diamonds in each round section. the smaller diamonds around the outside are 2pt each. All the diamonds are G/H colours and the light just bounces everywhere. With a total diamond weight of 5,4ct.